Rowenta ADVANCER DZ9130 - ADVANCER DZ9130 Deutsch

1103902655 DZ9000 F1 8/11/07 10:06 Page 16
None or too little
steam is being
emitted.
Brown streaks
come through
the holes in the
soleplate and
stain the linen.
Iron is leaking.
Steam control set on dry
position .
Not enough water in the
water tank.
Anti-Drip* is active (§ 12).
Residues in the steam
chamber or on the
soleplate.
Use of chemical descaling
agents.
Pure distilled/demineralised
or softened water
is being used.
Use of starch.
Fabric fibres have
accumulated in the holes
of the soleplate and are
burning.
Turn the steam control to the
required setting area.
Fill the water tank.
Wait for the soleplate to reach the
correct temperature.
Use the Self Clean function then
clean your iron.
Do not add any descaling agents
to the water in the water tank. Use
the Self Clean function and clean
your iron.
Only use untreated tap water or
mix half tap water with half
distilled/demineralised water. Use
the Self Clean function and clean
your iron.
Always spray starch onto the
reverse side of the fabric to be
ironed and clean your iron
soleplate.
Carry out a self-clean and clean the
soleplate.
Vacuum the holes of the soleplate
from time to time.
Your linen has not been Ensure linen is rinsed thoroughly
rinsed sufficiently or you to remove any soap deposits or
have ironed a new garment chemicals on new garments which
before washing it. may be sucked up by the iron.
Soleplate temperature too
low or overuse of shot of
steam button.
Set the temperature control to a
higher temperature and allow
more time between each shot.
If you have any further problems or queries please contact our
Customer Relations Team first for expert help and advice:
Helpline: 0845 602 1454 - UK.
(01) 4610390 - Ireland
Or consult our web site: www.rowenta.co.uk
Subject to modifications !
* depending on model
16