KompatibilnÃ:

Recommendations

Info

2010_compatibility_Buggypod_CZ.xls standartní nutno nutný objímky 51 dokoupit adaptér Značka Model v ceně objímky 70 partD Poznámka Peg Perego Aria Skate Venezia Young Culla Petite Star Kurvi Whirl Zia Quicksmart Easy Fold Quinny Buzz Dreami Freestyle Zapp Safety 1st Roadmaster Surf Silver Cross Classic Freeway Classic Halo S4 Steelcraft Strider Stokke Xplory Stroll-Air Spider Duo Teutonia Elegance Primus Y2K TFK Joggster II & III Twinner Twist Traxx Marlin 3 & 4 Urban Detour Vesta X-Lander XT X-Run Twin Revelo does not guarantee that the Buggypod will fit every make and model of pushchair. Customers should always follow our guidelines: The Buggypod can be attached to most buggies and pushchairs including twin buggies and 3 wheelers. The strap of the mounting brackets can be tightened around most buggy and pushchair frames. The frames can be oval, square, round, thick or thin. Size 51 brackets fit frames up to 4 cm diameter. Size 70 brackets fit frames more than 4 cm diameter The Buggypod is supplied with a set of size 51 brackets included. Size 70 brackets are available to purchase separately. To assess whether the Buggypod will fit your pushchair, you should check that there are exposed fixture points on two major frame bars on the right hand side of your pushchair. The rear fixture point needs to be approximately 35-43 cm from the floor. The front fixture point can be level with the rear fixture point or up to approx. 8 cm higher. Both fixture points need to be between 16 - 37.5 cm apart. 14/15 14
2010_compatibility_Buggypod_CZ.xls standartní nutno nutný objímky 51 dokoupit adaptér Značka Model v ceně objímky 70 partD Poznámka You cannot fit a bracket around two parallel telescopic bars, as the bars may slide alongside each other or split apart when folding pushchair (e.g. Bebeconfort Loola). You can fit the bracket on one telescopic bar if there is a gap of minimum 2 mm between the bars (e.g. Mamas and Papas Pliko). Check that the mounting brackets, once fitted, do not interfere with the braking system or folding mechanism of the host pushchair. Check that the bar to which you are fitting the bracket is vertical (looking from the rear or front), so that the bracket and Buggypod will sit vertically too. The front bracket can be fitted slightly higher than the rear bracket if it helps achieve a good connection. The Buggypod seat will then tilt back gently (as with many pushchairs) and you may in any case prefer that. You may find it helpful to look at the images of the Buggypod attached to a number of pushchair models in the Support pages at www.buggypod.com. If you are still unsure about whether the Buggypod will fit your pushchair, you can call our Helpline on 0870 850 3463 (M-F, 09:30-17:00) or email us at support@revelo.co.uk and we shall endeavour to help you. . Your local retailer may also be able to advise on fitting. 15/15 15
Page 1 and 2: 2010_compatibility_Buggypod_CZ.xls
Page 13: 2010_compatibility_Buggypod_CZ.xls

KompatibilnÃ­:

Create successful ePaper yourself

Delete template?

Save as template?

KompatibilnÃ: