BlackandDecker Torcia- Fsl12 - Type H2 - Instruction Manual (Ungheria)

ENGLISH
Other batteries could burst, causing personal injury
and damage.
♦ Never attempt to charge non-rechargeable
batteries.
♦ Have defective cords replaced immediately.
♦ Do not expose the charger to water.
♦ Do not open the charger.
♦ Do not probe the charger.
This appliance is intended for indoor use
only.
Read all of this instruction manual carefully.
The charger automatically shuts off if the
ambient temperature becomes too high. As
soon as the ambient temperature has cooled
down, the charger will resume operating.
Charge only at ambient temperatures
between 10 °C and 40 °C.
Features
This appliance has the following features:
1. On/off switch
2. Carrying strap
3. Battery
Fig. A, C and D
4. Battery release button
5. Charger
6. Charger receptacle
7. Charger connector
8. Charger plug
Assembly
Warning! Before assembly, remove the battery
from the appliance.
Fitting and removing the battery (fig. A)
♦ To fi t the battery (3), line it up with the receptacle
on the appliance. Slide the battery into the
receptacle and push until the battery snaps into
place.
♦ To remove the battery, push the release button
(4) while at the same time pulling the battery out
of the receptacle.
Fitting the battery cap (fig. B)
Warning! Fit the cap (9) to the battery (3) for
transportation and storage.
Charging the battery
The battery needs to be charged before fi rst use
and whenever it fails to produce suffi cient power on
jobs that were easily done before. When charging
the battery for the fi rst time, or after prolonged
storage, it will only accept an 80% charge. After
several charge and discharge cycles, the battery
will attain full capacity. The battery may become
warm while charging; this is normal and does not
indicate a problem.
Warning! Do not charge the battery at ambient
temperatures below 10 °C or above 40 °C.
Recommended charging temperature: approx.
24 °C.
Charging with the charger receptacle (fig. C)
♦ To charge the battery (3), remove it from the
appliance and slide the charger receptacle (6)
onto the battery.
♦ Plug in the charger (5).
After normal use, a charging time of 3 hours will
provide sufficient power for most applications.
However, further charging for up to 6 hours could
signifi cantly increase the use time, depending on
the battery and charging conditions.
♦ Remove the charger receptacle (6) from the
battery (3).
Charging with the charger plug (fig. D)
♦ To charge the battery, make sure that it is fi tted
on the appliance.
♦ Insert the charger plug (8) into the charger
connector (7).
♦ Plug in the charger (5).
♦ Switch the charger on at the mains supply.
After normal use, a charging time of 3 hours will
provide sufficient power for most applications.
However, further charging for up to 6 hours could
signifi cantly increase the use time, depending on
the battery and charging conditions.
♦ Disconnect the charger connector (8) from the
appliance.
Warning! Do not use the appliance while it is
connected to the charger.
Replacing the bulb (fig. E)
The bulb can be replaced easily.
Warning! Do not touch the bulb shortly after using
the fl ashlight, as the bulb may be hot.
♦ Remove the battery (3).
♦ Remove the bulb holder (10) by turning it counter
clockwise.
♦ Remove the bulb (11) by turning it slightly and
pulling it out of the bulb holder (10).
♦
♦
Insert a new bulb.
Re-fi t the bulb holder (10) into the fl ashlight and
turn it clockwise to secure it.
Maintenance
Your Black & Decker appliance has been designed
to operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
11