KitchenAid U 12 A1 D/HA - U 12 A1 D/HA PT (F093760) Istruzioni per l'Uso

INSTALLATION
• Install the appliance away from heat sources.
Installation in a hot environment, direct exposure to the sun
or installation near heat sources (heaters, radiators, cookers)
will increase power consumption and should therefore be
avoided.
• If this is not possible, the following minimum distances must
be observed:
- 30 cm from coal or paraffin stoves
- 3 cm from electric stoves.
• Install the appliance in a dry, well-ventilated place.
• Clean the interior (see "How to defrost and clean the
freezer").
• Check the door seal is not damaged or deformed, especially
after installation or reversal of door opening.
Electrical connection
• Electrical connections must be made in accordance
with local regulations.
• Voltage and power consumption are indicated on the rating
plate inside the appliance.
• Regulations require that the appliance is earthed. The
manufacturer declines all liabilities for injury to
persons or animals or damage to property resulting
from failure to observe these regulations.
• If the plug and socket are not of the same type, have the
socket replaced by a qualified electrician.
• Do not use extension leads or adapters.
Disconnecting the appliance
• It must be possible to disconnect the appliance by unplugging
it or by means of a two-pole switch fitted upline of the
socket.
1225 - 1233
min 50
min 550
560
min 200 cm 2
1224
540
540
58
1126
58
Door reversibility
1) Loosen the two screws securing the top hinge (left or right)
2) Remove the top hinge
3) Remove the door
4) Loosen the two screws securing the bottom hinge (left or
right)
5) Re-fit the two caps at the top on the opposite side
6) Re-fit the two caps at the bottom on the opposite side
7) Re-fit the top hinge at the bottom on the opposite side
8) Position the door on top of the bottom hinge pin
9) Re-fit the bottom hinge at the top on the opposite side
10) Screw in the two hinges
You will need a flat head screwdriver.
21