KitchenAid 5100800005 - 5100800005 EN (855164816030) Istruzioni per l'Uso
KitchenAid 5100800005 - 5100800005 EN (855164816030) Istruzioni per l'Uso
KitchenAid 5100800005 - 5100800005 EN (855164816030) Istruzioni per l'Uso
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
AFTER-SALES SERVICE<br />
Before contacting the After-Sales Service:<br />
1. Try to resolve the problem yourself (see “Try<br />
to resolve the problem yourself first”).<br />
2. Switch the appliance on and off to see if the<br />
problem is still there. If the problem is still<br />
there, switch the appliance off and switch it<br />
back on again after an hour.<br />
3. If the problem <strong>per</strong>sists, inform the After-<br />
Sales Service:<br />
Please provide the following information:<br />
• Nature of the fault<br />
• Appliance model<br />
• Service number (the number behind the<br />
word SERVICE on the specification plate<br />
inside the appliance)<br />
• Your full address<br />
• Your telephone number and area code<br />
Note:<br />
If the door hinge is replaced by the After-<br />
Sales Service, this does not fall under the<br />
guarantee.<br />
INSTALLATION<br />
• Do not install the appliance close to a<br />
heat source. Installation of the appliance<br />
in a warm room, close to sources of heat<br />
(radiators, ovens) or in direct sunlight<br />
increases the power consumption and<br />
should therefore be avoided.<br />
• If this is not possible, the following minimum<br />
distances must always be observed:<br />
• 30 cm from coal or oil-burning stoves;<br />
• 3 cm from electric and/or gas cookers.<br />
• Mount the spacers (if supplied with<br />
the appliance) on the rear panel of the<br />
condenser on the back of the appliance.<br />
• Install the appliance in a dry and wellventilated<br />
location and level it if necessary<br />
using the adjustable front feet.<br />
• Clean the inside compartment.<br />
• Install the accessories.<br />
• The appliance must be grounded by law.<br />
The manufacturer is not liable for any<br />
injury to <strong>per</strong>sons or animals, or damage<br />
to pro<strong>per</strong>ty due to non-compliance with<br />
the directions given above.<br />
• If the plug and socket are not of the same<br />
type, have the socket changed by a<br />
qualified electrician.<br />
• Do not use extension leads or multiple<br />
adapters.<br />
Electrical disconnection<br />
It must be possible to disconnect the appliance<br />
by disconnecting the plug from the mains<br />
supply or via an upstream two-pin switch.<br />
Electrical connection<br />
• The electrical connections must comply<br />
with local regulations.<br />
• Information on the voltage and power input<br />
is given on the specification plate inside the<br />
appliance.<br />
11