Ecostat S 15715000 PuraVida 15772XXX Metris ... - Hansgrohe
Ecostat S 15715000 PuraVida 15772XXX Metris ... - Hansgrohe
Ecostat S 15715000 PuraVida 15772XXX Metris ... - Hansgrohe
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
6 Safety Notes<br />
6 Gloves should be worn during installation to prevent<br />
crushing and cutting injuries.<br />
6 The shower system may only be used for bathing,<br />
hygienic and body cleansing purposes.<br />
6 Children as well as adults with physical, mental and/<br />
or sensoric impairments must not use this shower<br />
system without proper supervision. Persons under<br />
the influence of alcohol or drugs are prohibited from<br />
using this shower system.<br />
6 The hot and cold supplies must be of equal pressures.<br />
Installation Instructions<br />
• Prior to installation, inspect the product for transport<br />
damages. After it has been installed, no transport or<br />
surface damage will be honoured.<br />
• The fitting must be installed, flushed and tested after<br />
the valid norms!<br />
Technical Data<br />
Operating pressure: max. 1 MPa<br />
Recommended operating pressure: 0,1 – 0,5MPa<br />
Test pressure:<br />
(1 MPa = 10 bar = 147 PSI)<br />
1,6MPa<br />
Hot water temperature: max. 80°C<br />
Recommended hot water temp.: 65°C<br />
Rate of flow by 0,3 MPa:<br />
• anti-pollution function<br />
approx. 58 l/min<br />
• The product is exclusively designed for drinking water!<br />
6<br />
English<br />
Symbol description<br />
Do not use silicone containing acetic acid!<br />
Safety Function (see page 62)<br />
The desired maximum temperature for example<br />
max. 42º C can be pre-set thanks to the<br />
safety function.<br />
Adjustment (see page 62)<br />
After the installation, the output temperature<br />
of the thermostat must be checked. A<br />
correction is necessary if the temperature<br />
measured at the output differs from the<br />
temperature set on the thermostat.<br />
Maintenance (see page 64)<br />
• To guarantee the smooth running of the<br />
thermostat, it is necessary from time to<br />
time to turn the thermostat from total hot<br />
to total cold.<br />
• The mixer is equipped with non return<br />
valves. The non return valves must be<br />
checked regularly according to DIN EN<br />
1717 in accordance with national or regional<br />
regulations (at least once a year).<br />
At this time, please also check the filter<br />
(A) situated on the BTC-thermoelement<br />
(96633000). After assembling the BTCthermoelement,<br />
it is necessary to check<br />
the water temperature at the take off<br />
point as described under the headline<br />
„adjustment“. Before the adjustment,<br />
please check, if the warm water supply is<br />
activated and the maximum temperature<br />
of the warm water is available at the take<br />
off point.