You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Section<br />
03<br />
18<br />
Connections<br />
Important<br />
! When this unit is installed in a vehicle without<br />
ACC (accessory) position on the ignition<br />
switch, red cable must be wired to the terminal<br />
that can detect the operation of the ignition<br />
key. Otherwise, battery drain may result.<br />
ACC position No ACC position<br />
! Use of this unit in conditions other than the<br />
following could result in fire or malfunction.<br />
— Vehicles with a 12-volt battery and negative<br />
grounding.<br />
— Speakers with 50 W (output value) and 4<br />
ohm to 8 ohm (impedance value).<br />
! To prevent a short-circuit, overheating or malfunction,<br />
be sure to follow the directions<br />
below.<br />
— Disconnect the negative terminal of the<br />
battery before installation.<br />
— Secure the wiring with cable clamps or adhesive<br />
tape. To protect the wiring, wrap adhesive<br />
tape around them where they lie<br />
against metal parts.<br />
— Place all cables away from moving parts,<br />
such as gear shift and seat rails.<br />
— Place all cables away from hot places,<br />
such as near the heater outlet.<br />
— Do not pass the yellow cable through a<br />
hole into the engine compartment to connect<br />
to a battery.<br />
— Cover any disconnected cable connectors<br />
with insulating tape.<br />
— Do not shorten any cables.<br />
— Never cut the insulation of the power cable<br />
of this unit in order to share the power<br />
with other devices. Current capacity of the<br />
cable is limited.<br />
— Use a fuse of the rating prescribed.<br />
— Never wire the speaker negative cable directly<br />
to ground.<br />
— Never band together multiple speaker’s negative<br />
cables.<br />
En<br />
OFF<br />
ON START<br />
! Control signal is output through blue/white<br />
cable when this unit is powered on. Connect it<br />
to an external power amp’s system remote<br />
control or the vehicle’s auto-antenna relay<br />
control terminal (max. 300 mA 12 V DC). If the<br />
vehicle is equipped with a glass antenna, connect<br />
it to the antenna booster power supply<br />
terminal.<br />
! Never connect blue/white cable to external<br />
power amp’s power terminal. Also, never connect<br />
it to the power terminal of the auto antenna.<br />
Otherwise, battery drain or malfunction<br />
may result.<br />
! Black cable is ground. This cable and other<br />
product’s ground cable (especially, high-current<br />
products such as power amp) must be<br />
wired separately. Otherwise, fire or malfunction<br />
may result if they are accidentally detached.<br />
130.com.ua<br />
Autogood products internet store http://130.com.ua