Untitled - Ega Master

It is supplied a spray bottle to spray the area around the freezer form and pipe withwater before using the electric pipe freezer. This operation must be done more frecuentlywhen the freezer form begin to show signs of freezing.• USEThe freezer forms should be connected tightly to the pipe using the velcro strapsprovided.Once the plug has been correctly inserted into the wall socket with an earth connection,the switch on the unit can be put inot the ON position and the freezing process can bestarted.To help the cold contact between the freezer hedad and the pipe, water must besprayed frequently between the freezer form and the wall of the pipe. Spraying is mostefficient when started after the freezer forms have shown the first signs of freezing.Thehumidity must be kept up to the final freezing. This way, we will help to reduce the freezingtimes.After a certain time (see freezing times table), ice starts to form inside the pipe andcreates frost formation on the surface of the pipe. If this does not happen, then this indicatesthat there is some flow in the pipe (turn off the pump, prevent water from being drained offand allow the water to cool down).Pipe Ø1/8”10-12mm¼”14-16mm3/8”16-18mm½”22mm¾”28mm1”35mm1.1/4”42mmFreezing timesPipematerialSteelCopperSteelCopperSteelCopperSteelCopperSteelCopperSteelCopperSteelCopperFreezing times(minutes)33,545,56791114,51716203133• MAINTENANCE1) Regularly inspect the Freezematic for damage on both freezer forms, the coolantpipes and the electric cable2) The user is not permitted to carry out repairs by himself because the guarantee willthen no longer be valid and besides, there will be an increased risk of a short circuit3) Always turn off the Freezematic and remove the plug from the wall socket beforecarrying out any maintenance work4) At least once a year, the condenser, which is behind the grille above the feet, mustbe blown clean usin compressed air with a maximum pressure of 3 bar