Print TBOS manual (ENG/sp) - Rain Bird

englishTBOS Field Transmitterenglish5. Repeat steps 3 and 4 until you have set all of thestart times you desire (up to eight per program)for the program.6. If you would like to set start times for additionalprograms, pressAuntil the program you desireis displayed. Then repeat steps 3 and 4.7. When you have finished setting the start times,press B to move to theHicon, Setting theWatering Time Length display.Deleting a start timeTo delete a start time:1. Press B to advance to the G icon.2. PressAto change to the appropriate program.3. PressCto scroll through the start times untilthe start time you want to delete is displayed.(The start times will be in chronological order).4. Press Oor Puntil the blank position(--:--) appears in the display. The blank positionis located between 11:59 and 12:00 (AM or PM).5. PressCto scroll through the remaining starttimes and confirm the deletion.Setting the run time per stationYou can set the run time for each station from 0 to 12hours (in one minute increments). All One StationControl Modules must be programmed on station 1.Multi-station Control Modules (Two, Four, or SixStation) must be programmed starting on station 1.For example, on a Four Station Control Module, programmingwould start on station 1, then station 2, 3and 4.Note: Each station may be assigned toonly one program (A, B or C)! The stationwill only respond to the start timesand days on for this program.12Note: The time display is represented inhours and minutes. The first two placeholdersare for hours; the second twoplaceholders are for minutes.To set the run time:1. Make certain the H icon isvisible on the display. If it isnot, press B repeatedlyto cycle through the menusystem and display the Hicon.2. The station number appears to the left of the runtime. UseCto select the station.3. Press A repeatedly until the program you desire(A, B, or C) flashes in the display (to the right ofthe run time). Each station must be assigned to aprogram (A, B, or C).4. Use OandPto set the station run time.5. PressCto move to the next station.6. Repeat steps 3 through 5 until you have set all ofthe station run times.Note: If there is an overlap on the samestation, the second run time will nottake place.7. When you have finished setting the run times,you may review the run times by pressingC .Erasing Field Transmitter programming dataTo erase all program data in the Field Transmitter(except the current time and day):Press and hold OandPsimultaneouslyfor atleast three seconds.All programming data are erased.13