Water Dispenser Distributeur d'eau - Greenway Water Technology
Water Dispenser Distributeur d'eau - Greenway Water Technology
Water Dispenser Distributeur d'eau - Greenway Water Technology
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
3. To access the reservoir system, you must remove the top cover on the dispenser (See Fig. 17) by removing the two<br />
Philips screws located at the rear of the cover (See Fig. 17A).<br />
4. Carefully lift off the top cover.<br />
5. Remove the black reservoir cover by carefully pulling upward (See Fig 17B).<br />
6. If using a <strong>Greenway</strong> ® water dispenser cleaning solution, please follow the manufacturer’s instructions provided with<br />
the cleaning kit. If using a pre-mixed solution of 15ml (1 tbsp) bleach with 4.5L (1.2 gal) of hot water, fill the reservoir<br />
and let stand for 20 min.<br />
7. Press both dispensing taps until the cleaning solution stops flowing (collect the cleaning solution into a container/<br />
bucket).<br />
8. Flush the reservoir with clean water and press both dispensing taps until<br />
water stops flowing (collect the water into a container/bucket).<br />
9. To drain any remaining water from the reservoirs, remove (unscrew) the<br />
drain cap and plug located at the rear of the dispenser (See Fig. 18).<br />
Collect the water into a container/bucket. IMPORTANT: Remember to<br />
re-install the drain cap and plug and tighten (See Fig. 18).<br />
10. Re-install the reservoir cover by pressing down firmly.<br />
11. Re-install the dispenser top cover and secure using the two Philips screws.<br />
12. Re-connect the power cord.<br />
Fig. 18<br />
13. Re-open the manual shut-off valve (you will hear water entering the system<br />
which will stop automatically when the appropriate water levels are reached).<br />
14. Place a container under the water spigots and press both dispensing buttons (separately) to make sure water is<br />
flowing normally from each side.<br />
op e r at In G In s t r u c t Io n s:<br />
IMPORTANT NOTE: Your <strong>Greenway</strong> ® water dispenser is designed with a special “safety” feature (float switch mechanism)<br />
that controls activation/operation of the “Kettle Feature” hot water tank heating system. If no water is present and/or low<br />
water levels are detected inside the internal reservoir system, activation/operation of the hot water heating system is not<br />
possible. Likewise, if the hot water heating is operational and water is being drawn simultaneously causing water levels<br />
to drop below safe levels, hot water tank operation is automatically terminated until normal water levels are restored,<br />
at which time you must “manually” re-activate the hot water heating system by pressing the kettle feature (red) button.<br />
NOTE: Operation of the cold water system is not affected by this safety feature.<br />
Child Resistant Safety Switch:<br />
DO NOT ALLOw CHILDREN TO USE THE HOT wATER DISPENSING<br />
BUTTON wITHOUT PROPER AND DIRECT SUPERVISION.<br />
To prevent hot water from being dispensed accidentally and possibly harming<br />
a child, the hot water dispensing button can only be operated when the child<br />
resistant safety switch is activated. To dispense hot water, push/hold the child<br />
safety switch sideways (in the direction of the arrow located on the switch)<br />
from right to left, then press/hold the hot water button (as soon as water starts<br />
flowing you can release the child safety switch) until the desired amount of hot<br />
water is dispensed. Upon releasing the hot water button, the child safety switch<br />
automatically re-engages to the locked position.<br />
7<br />
Child<br />
resistant<br />
safety<br />
switch