Émotion Barres - Thermor

More documents

Recommendations

Info

2/ Release the device’s hook-on bracket We recommend that you place the device flat, face down. Have a straight head screwdriver to hand. 3/ Fix the hook-on bracket Drilling points B Drilling points A Drilling points A
4/ Connecting the device - The device must be supplied with 230V, 50Hz. - Mains connection must be ensured using the 3- wire cable factory fitte to the heater , through a connecting box. In damp premises, such as bathrooms and kitchens, install the connecting box at least 25cm from the ground. - To prevent hazards due to unintentional resetting of the thermal circuit breaker, this device should not be powered through an external switch, such as a time switch, or connected to a circuit which is switched on and off on a regular basis by the electric power supplier. - The installation must comply with local national regulation. If in doubt, ask the national Atlantic distributor. Panel heater cable Phase=brown Neutral=blue Pilot wire=Black 1st case: only one heater 2nd case: Slave heater 3rd case: Master heater Three possible cases - Ground connection is forbidden. Do not connect the pilot wire (black) to ground. - If power cable is damaged or too short, to avoid any danger it must be replaced by a qualified electrician using special tools. - If a heater pilots or is piloted by a 30mA differential (e.g. bathroom), the pilot wire supply must be protected on this differential. PHASE NEUTRAL Electricity grid The pilot wire end is insulated and not further connected To the appliance with cassette or programming unit. To pilot wire of an electronically controlled appliance Chart indicating the orders the device can receive over its pilot wire (to be measured between the pilot wire and the neutral). Orders received Current absent Ref/neutral oscilloscope Full wave 230V Negative half wave -115V Positive half wave +115V GB Mode achieved COMFORT ECO STANDBY STOP HEATING LOAD SHEDDING 5/ Lock the device on the hook-on bracket S2 CLICK S1 13
Page 1 and 2: Notice d’installation et d’util
Page 3 and 4: Sommaire Installation 1/ Préparer
Page 5 and 6: Installation 1/Préparer l’instal
Page 7 and 8: 4/ Raccorder le panneau rayonnant R
Page 9 and 10: Utilisation 1/Chauffer votre pièce
Page 11 and 12: 1/Conseils d’utilisation Conseils
Page 13: The device you have just purchased
Page 17 and 18: Heating indicator V1 This shows whe
Page 19 and 20: MAINTENANCE - To maintain the perfo
Page 21 and 22: 2/ Het bevestigingssysteem van het
Page 23 and 24: Beschrijving van het bedieningspane
Page 25 and 26: WAARSCHUWING - Voorkom dat kinderen
Page 27 and 28: 2/ Die Befestigungsklaue am Gerät
Page 29 and 30: Beschreibung des bedienungsgehäuse
Page 31 and 32: SICHERHEITSHINWEISE - Achten Sie da

Émotion Barres - Thermor

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?