You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Advices for<br />
operation<br />
Maintenance<br />
Accessories<br />
ENGLISH<br />
Hints<br />
5<br />
Exerting greater pressure does not increase the machine’s effectiveness!<br />
The Anti–Vibration–System will work at an<br />
optimum when normal working pressure is<br />
applied; the shock absorber is then only<br />
slightly pressed together.<br />
If the applied working pressure is too high,<br />
the shock absorber is strongly pushed<br />
together and the vibrations are noticeably<br />
transmitted to the handle.<br />
Take the drill out of the hole from time to time to remove dust.<br />
Switch to percussion-drilling for concrete, hard bricks and tiles, stone, hard cement,<br />
and marble (but not when drilling the surface of marble).<br />
For tiles, paving-stones, soft bricks and tiles, soft cement, breeze-block and plaster,<br />
switch to normal drilling.<br />
Use percussion carbide tipped masonry drill-bits.<br />
When drilling a hard, smooth surface (e.g. tiles), cover the point to be drilled with<br />
adhesive tape in order to prevent the drill bit tip from skidding.<br />
Should the hammer action deteriorate send it to one of our Service Stations.<br />
The ventilation slots of the machine must be kept clear at all times.<br />
The machine is fitted with carbon brush that automatically switch it off if they are<br />
worn, before the motor can be damaged.<br />
If the carbon brushes cut-out or the hammer capacity declines please contact your<br />
authorized AEG service station. This will ensure long service life as well as constant<br />
readiness for working of the machine.<br />
The location of your neerest service station is shown in our “Service adresses” leaflet<br />
attached to each product.<br />
Use only AEG accessories and spare parts. Should components need to be<br />
replaced which have not been described, please contact one of our AEG service<br />
agents (see our list of guarantee/service addresses).<br />
If needed, an exploded view of the tool can be ordered. Please state the ten–digit<br />
No. as well as the machine type printed on the label and order the drawing at your<br />
local service agents or directly at: Atlas Copco Elektrowerkzeuge GmbH,<br />
Postfach 320, D–71361 Winnenden.<br />
The range of accessories with part numbers is shown in our catalogue.<br />
<strong>PNEUMATIC</strong> <strong>6000</strong> S
Change language