INSTRUCTION MANUAL - Team ORION JAPAN

Cycle Mode
ENGLISH
From the main screen, use the + or - keys to select the
cycle mode from the main screen (indicated by “CYCLE
MODE”). The cycle mode is used to do an automatic
charge->discharge or discharge->charge cycle to your
batteries. Cycling is useful for checking your batteries
performance and regenerating batteries which have been
stored for a certain period of time.
Depending on the type of cycle you have selected, the charge or discharge screen will be displayed.
Charge screen
Discharge screen
ENGLISH
The charger uses the actual charge and discharge settings. Make sure that these settings are
compatible with the battery.
After discharge It is recommended to recharge LiPo batteries as they can be damaged if stored empty.
Once the cycle is complete, the “CYCLE COMPLETE” message is displayed”.
From the cycle screen, press “ENTER” and use “+” or “-“ to select if you want to make a charge->
discharge or discharge->charge cycle to your battery. To regenerate batteries, use the charge->
discharge cycle. It is recommended to use only low discharge currents for discharge->charge cycling
as high currents can overheat and damage the battery.
After you have selected the cycling mode, press and hold
the ENTER key. The battery check will be displayed.
Charge->discharge cycle
end screen
Discharge->charge cycle
end screen
Note: depending on the conditions of use, the charger thermal protection might activate so that
the charger can cool down. After a brief interruption the charge or discharge will resume and
continue normally.
22
Team Orion Advantage Race Spec
www.teamorion.com 23