Ifö Cera - Sanitec

GB
To set the flushing
All WC suites are preset at the factory
for a flushing volume of 4 litres for full
flush and 2 litres for half flush. Float
hook position 4.0 cm for large (Dark
grey) and 1.5 cm for small (Light grey).
The flushing volume can be altered, if
necessary. See the flushing volume
table on the preceding page.
Proceed as follows
Unhook the bottom waste valve
assembly 6 , 7 from the overflow
pipe and lift it out of the cistern. Release
the float hook and push the float
upwards to reduce the flushing volume
and downwards to increase it.
8
Ifö Cera
Thank you for choosing the Ifö Cera.
You have made a wise choice by deciding on this environmentally appropriate, easy-toclean
and elegant WC suite. To gain full benefit, it is important for the fitting and installation
work to be carried out in accordance with our instructions. This will assure you of a reliable
and practical WC suite that will give maximum satisfaction for many years.
To remove the push-
volumes button and cover nut
The indicated flushing volumes may vary by ± 0,25 litre.
Flushing volume, litres Float hook position, cm
Full flush and half flush Remarks
Dark grey Light grey
Remove the push-button and cover nut
as shown in the drawings 1 2 3 .
If the WC unit is leaking - check the
inlet valve plunger and the valve ring of
the bottom waste valve assembly.
If the O-ring or gasket on plunger
96481 5 is damaged, replace the
plunger.
If valve ring 96308 8 is damaged, fit a
new valve ring.
3,0 2,0 1,0 1,0 Same flusching volume
3,5 2,0 2,5 1,5 -"-
4,0 2,0 4,0 1,5 -"-
6,0 3,0 8,5 4,0 -"-