How to configure your router for satellite connection

How to Configure Your Netgear Router for Satellite
Connection?
If you have purchased a new Netgear Router and don’t know how to configure it for your
satellite connection then, follow the given instructions mentioned in this blog to use your
internet with the Netgear Router
1. Remove the modem cable from the router and connect the PC to a router LAN port.
2. Now, connect the PC to a router LAN port.
3. Open any web browser on your system and type http://192.168.0.1 in the address bar.
4. Enter Admin in the Username section and Password in the Password section.
5. Click on the OK button and then select Advanced from the left side pane.
6. Locate LAN IP Setup and change IP Address to 192.168.10.2
7. Once this is done, change Ending IP address to 192.168.10.51.
8. Now, click on the Apply button. This will show you an error “Page cannot be displayed”
or “Action Cancelled”.
9. Now, close your web browser and “power off” the router.
10. Once this is done, connect the modem to the router Internet port and move to the next
step.
11. Now, turn on the router and restart the PC. Again, open a browser and type
http://192.168.10.1. Hit Enter key.
12. Enter Admin in the Admin section and Password in the Password section. Please note
that older routers have default secret keys 1234.
13. Hit the OK button and then go to Setup Wizard under the left of the router settings
page.
14. Check yes, and then click on the Next button.
15. Select Apply and then Logout on the router settings screen.
If you have any doubt related to this method then feel free to contact us via toll-free Netgear
Support Phone Number +44-208-089-0419. In case of any issue, customers are always welcome
to contact us.
Original Source: https://netgearsupportuk.home.blog/2018/12/10/how-to-configure-yournetgear-router-for-satellite-connection/