SUC Industry - Kongskilde
SUC Industry - Kongskilde
SUC Industry - Kongskilde
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Starting<br />
It is recommended that the slide of<br />
the intake nozzle is fully open or<br />
the nozzle removed from the material<br />
when starting the suction blower.<br />
Adjust the intake nozzle for maximum<br />
capacity when the blower has<br />
reached full speed.<br />
Lock the air intake regulator in<br />
starting position before starting the<br />
blower. The air intake regulator is<br />
limiting the blower’s air capacity in<br />
order to lower the load on the motor<br />
and thereby the consumption of<br />
amp during the start.<br />
Adjustment for<br />
maximum capacity<br />
The function of the slide is to ensure<br />
correct balance between air<br />
and grain.<br />
If the slide is open too far, there will<br />
be too much air and too little material<br />
conveyed.<br />
If the slide is closed too far, there<br />
will be too little air and the material<br />
will settle in the pipe system, and<br />
may block the pipe system completely.<br />
16<br />
Open<br />
Closed<br />
Open the slide on the intake nozzle<br />
fully and place the end of the intake<br />
nozzle in the material.<br />
Then slowly turn the slide on the<br />
intake nozzle from the fully open<br />
position towards the closed position.<br />
Note: It is only necessary to lock<br />
the air intake regulator if the reduction<br />
in amp consumption is<br />
demanded by the local power<br />
supply.<br />
Just before the pointer of the blower<br />
air regulator enters the red area<br />
the suction head slide is correctly<br />
adjusted.<br />
When the blower is fully running,<br />
release the air intake regulator<br />
again (<strong>SUC</strong> 300E/<strong>SUC</strong>500E can be<br />
delivered with automatically controlled<br />
air intake regulator).<br />
When working, the air intake regulator<br />
maintains a uniform air volume,<br />
even when the back pressure<br />
varies during operation. This reduces<br />
the load on the blower motor.<br />
The air intake regulator is sealed<br />
from the factory and must not be<br />
adjusted.<br />
Start<br />
Conveying