g30 42 mm - Normstahl

18340_EUR_42mm_TOF_TOR 05-09-14 13.03 Sida 10
22.
Close the door and fix the lock-cable including the small
washer to the handle cover
NOTE: on the left fixing point (1), Fix the end cap on the
cable cover and slide the cable through the cover. Screw to
the door section by 6-9 clips (5) and screw the clips into
the end stiles. Fix adjustment bracket and adjustment
screw at the upper section joint (2) and fix the cable to the
lock. (3)
Tie the white release rope to the lock (4) and adjust the
lock-catch to get a distance of 3-4 mm lock catch to lock
latch (5). Pull the release rope through the rope-guides and
tie the black knob to the rope. Tie the pull down rope to
the corner bracket and
fix a rope-guide to the wall at approximately half the
opening height. (6)
To get a better handgrip of the rope, tie knots on the rope
from the rope bracket down to the floor. Cut the rope to
length if necessary.
Apply a drop of oil to all side- and mid-hinges and to the
lock catch.
Adjust the lock cable wire at the adjustment screw (2) to
get the correct tension on the lock spring by having the
lock part in centre of the steel tip see X-X distance (7).
Adjust the stop screw (8) to a position close to the catcher.
Fix the logo on outside (to section 2 if the door has a
handle or to the bottom section if the door does not have a
handle). Two small pre-punched holes give the position.
Before pressing the logo on to the section, remove the
glue protective film on the back.
TROUBLESHOOTING
The door is difficult to open and / or close
Adjust the torsion springs to add / remove spring tension.
Align ceiling runners and curved segments.
Measure corner to corner on the ceiling tracks. This
measurement should be equal. If not, reposition the tracks
to ensure they are parallel and square to the opening.
Door travels up or down independently from any height
Adjust the torsion springs to add / remove spring tension.
Torsion springs are subject to high pressure. Adjustment
must only be carried out by qualified personnel
Torsion spring fractured
The following components are to be replaced:
Complete spring unit left and right consisting of: Winch
drum, spring holder with spring fracture protection, torsion
shaft mount, springs and centre coupling.
The door panel must not be removed under any circumstances!
Non-compliance can result in rope jumping from
winch drum with subsequent uncontrolled fall of the door.
The door must be repaired by qualified personnel.
1010