Anleitung - Graupner

TOOLSIn addition to the tool that accompanied the vehicle, the following tools are useful and - in some cases -necessary:• Small fl at and small Phillips screwdrivere.g. No. 98116.12 and 98116.15• Needle nose pliers• Glow-Plug Screwdriver• Phillips screwdriver # 1 or # 0• Hex wrench with 1.5 mm, 2 mm and 2.5 mmCHARGING THE BATTERY PACKFirst you must load the battery pack with the enclosed battery charger.Battery capacity Charging time approx. In order to charge the battery pack must be connected to the battery charger,the loading procedure starts automatically. Disconnect the battery1800 mAh 5 hfrom the charger according to the time indicated in the chart or if it becameslukewarm. Never charge the batteris unsupervised! Read also2400 mAh 7 h3000 mAh 9 hthe enclosed battery safety instructions!4000 mAh 12 hTHE REMOTE CONTROL SYSTEMHere you get an overview of the remote control system of the Radicator-RTR and its various functions and settings.Before the first trip you should know and understood these functions.Place 8 AA batteries in the battery compartment of the transmitter. Pay attention to the polarity!Remote Control (transmitter)1. On / off switch: Turns the power on/off2. Steering wheel: Controls direction (left/right) of the model3. Steering trim: Adjusts the “hands off” direction of the model4. Throttle Trigger: Controls speed (forward/brake) of the model5. Throttle Trim: Adjusts the motor speed to stop at neutral6. Control light: indicates adequate battery power7. Antenna: Transmits signal to the model8. Servo reverse: Reverses the function of the steering or throttle (here are no adjustments necessary)GM-Racing 90500 - 90500.RTR Radicator 4WD 06