Water Evaporator
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
STRUB+Co. AG • Swiss Tribology<br />
Mühlemattstrasse 5 • CH-6260 Reiden<br />
Phone +41 62 785 22 22 • Fax +41 62 785 22 33<br />
sales@strub-lube.ch • www.strub-lube.ch<br />
<strong>Water</strong><br />
<strong>Evaporator</strong>
HOW DOES<br />
IT WORK?<br />
The heat transfer is possible thanks to the heat pump system via a conical jacket at the base of<br />
the boiling chamber. The inner heating surface is continuously cleaned by scrapers, which also<br />
act to stir the concentrate: this allows a waste concentration achieving the highest viscosity<br />
levels also in presence of sediment. The evaporation at a low boiling point is made possible<br />
by the vacuum condition generated by the pump and the ejector. The unit operates in semi<br />
batch operation: wastewater is constantly treated, the distillate is continually separated and<br />
then discharged through a pump, while the concentrate is discharged at the end of the cycle<br />
through a pump as well.<br />
Evaporation temperature (°C): 40°<br />
Achievable concentration in TS: 25 - 35%
Heat Pump<br />
EVALED®<br />
PC R series<br />
Heat pump scraped<br />
vacuum evaporators<br />
A solution for small flows<br />
to obtain high concentrate sludge<br />
Maximum volume reduction<br />
allow a return on investment often measured in months.<br />
Low boiling temperature<br />
ideal in case of very agressive salty wastewater.<br />
Suiteable for temperature sensitive products.<br />
PC R1<br />
R 150<br />
<strong>Water</strong><br />
<strong>Evaporator</strong>
Benefits<br />
EVALED® PC R<br />
EVALED PC R is a range of heat pump vacuum evaporators designed to treat liquids<br />
with a high content of dissolved solids at low temperature and ableto manage a high<br />
level of fouling and scaling phenomena (viscous liquids, sediment presence). The line is<br />
dedicated to water reuse.<br />
• Maximum water recovery, minimum quantity of waste to be disposed of<br />
• High quality of recovered water suitable for reuse<br />
• Low energy consumption<br />
• Suitable for very scaling and fouling liquids<br />
• Modular and flexible, short delivery time<br />
• Skid mounted (small footprint) and ready to use (plug & play unit)<br />
• Fully automatic, minimal manpower<br />
• Constant monitoring by remote control<br />
• User-friendly (intuitive HMI)<br />
<strong>Water</strong><br />
<strong>Evaporator</strong>
Technical Data<br />
EVALED® PC R1<br />
Electrical Equipment<br />
Maximum production of distillate with water in 24 hours<br />
Absorbed power<br />
Specific electrical consumption per litre of distillate<br />
Heat generated by thermal dissipation<br />
400 V 50 Hz 3P<br />
1080 lt<br />
10 kW<br />
220 Wh/lt<br />
9 kW/h<br />
Maximum air flow of finned pack 6200 Nm 3 /h<br />
Concentrate volume for each discharge<br />
200 lt<br />
The data reported in the table (values tolerance +/- 10 %) refer to the performance achived during the FAT<br />
(Factory Acceptance Test) with clean machine fed with tap water under atmospheric presure<br />
EVALED® R 150<br />
Electrical Equipment<br />
Maximum produciton of distillate with water in 24 hours<br />
Absorbed power<br />
Specific electrical consumption per litre of distillate<br />
Heat generated by thermal dissipation<br />
230 V 50 Hz 1P<br />
170 lt<br />
2,6 kW<br />
380 Wh/lt<br />
2,3 kW/h<br />
Maximum air flow of finned pack 1000 Nm 3 /h<br />
Concentrate volume for each discharge<br />
17 lt
1<br />
Customer Requirements<br />
2<br />
Offer / Return of Investment<br />
3<br />
Analysis / Warranty<br />
4<br />
Business<br />
5<br />
Strategy<br />
6<br />
Installation<br />
7<br />
After-Sales Service<br />
<strong>Water</strong><br />
<strong>Evaporator</strong>
1<br />
Customer Requirements<br />
Start your Project<br />
Step 1<br />
Fill out the Form and get an offer and return of investment for your needs.<br />
Send the filled form via Mail to us<br />
Step 2<br />
We will check the requirements and will contact you soon.<br />
water@strub-lube.com - Mühlemattstrasse 10 - CH-6260 Reiden<br />
We will inform you<br />
Step 3<br />
With our solution we will suprise you!
<strong>Water</strong><br />
<strong>Evaporator</strong><br />
Contact<br />
STRUB Swiss Tribology is a traditional family-owned company in the heart of Switzerland and<br />
has been an independent manufacturer of lubricants and technical cleaning agents since 1921.<br />
We have some 150 employees working in our business worldwide. Having branch offices and<br />
representatives in over 60 countries guarantees close proximity to our clients and the ability<br />
to react promptly to their specific needs.<br />
www.strub-lube.ch<br />
Sales Questions:<br />
sales@strub-lube.ch<br />
Tel.: + 41 (0) 62 785 22 22<br />
FAMILY COMPANY SINCE 1921