Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
6 Disassembling for transport<br />
5.1.1 Adjusting the handle height<br />
For easy transportation the motor and the guide tube can be removed.<br />
1. Lower the main lifting lever ( 1 ) to the front.<br />
2. Slide the clamp sleeve ( 2 ) to the top and take apart the connecting rod ( 3 ).<br />
6.1 3. Removing Loosen the guide clamp tube bolt ( 4 ).<br />
4. Pull the locking stud ( 5 ) and have it snapped in at the desired position.<br />
5. Assemble the connecting rod ( 3 ) on this position.<br />
Caution!<br />
Injury to the operator or other persons could occur or damage could occur if the machine<br />
starts up unintentionally. Disconnect the machine from the power supply before working<br />
on the machine!<br />
2<br />
0<br />
1<br />
1<br />
0<br />
5.2 Mounting the dust pipe<br />
Instructions:<br />
1. Fold down the cable arm (3).<br />
2. Move the main lifting lever (2) to the front position in order to lower the sanding drum to the<br />
floor. This removes the load from the control rod (5).<br />
3. Loosen both of the wing screws a little (4). Push the handle down to detach the control rod<br />
(5) from the connector (8).<br />
4. Open the guide tube support (7) with the clamping lever (6) and pull the guide tube (1) out.<br />
Insert the dust pipe ( 1 ) into the pipe connection ( 2 ) while gently rotating it.<br />
It is sealed with 2 O-rings.<br />
Pallmann Cobra <strong>II</strong> <strong>Manual</strong> 9