PI 0034 - MS Motor Service France SAS
PI 0034 - MS Motor Service France SAS
PI 0034 - MS Motor Service France SAS
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
© <strong>MS</strong> <strong>Motor</strong> <strong>Service</strong> International GmbH – 02/06 EN<br />
Model e1S<br />
www.ms-motor-service.com<br />
<strong>MS</strong> <strong>Motor</strong> <strong>Service</strong> International GmbH · 74196 Neuenstadt · Germany<br />
<strong>PI</strong> <strong>0034</strong><br />
<strong>PI</strong>erburg No. Nominal Stat. pressure Volume System Installation, resp. connection<br />
Current Max. suction<br />
voltage at Q=0 l/h fl o w pressure dimensions (see Fig. below)<br />
consumption height<br />
at Ø A b C Ø D Ø e<br />
[V] [bar/(psi)] [l/h] [bar/(psi)] [mm] [A] [mm]<br />
7.21088.62.0 12 – 75 0,24 (3,5) 38 100 75,3 8 19 3 0<br />
B<br />
A<br />
E<br />
D<br />
Ø 54,5<br />
C<br />
The E1S is off ered for installation within<br />
a fuel tank.<br />
This pump is a fl ow type pump with a<br />
side channel pumping stage for 12 Volt<br />
operation.<br />
This pump is preferably used as a prepump.<br />
Pre-pumps pump the medium<br />
at low pressure in the direction of the<br />
main pump.<br />
This prevents the generation of a lowpressure<br />
on the suction side of the main<br />
pump which might damage the main<br />
pump due to cavitation.<br />
Volume fl ow<br />
For technical personnel only!<br />
Page 5/8<br />
!Maximum suction height: 0 mm.<br />
The pump must be placed<br />
within the medium which is<br />
being pumped.<br />
Model E1S pumps can be used up to a<br />
volume fl ow of approximately 220 l/h as<br />
a pre-pump.<br />
Pump pressure<br />
Current at nominal voltage