Rod Logic 1-bit Full Adder in LEGO - The Half-Baked Maker

Recommendations

Info

This is the end to push. You could mark it with another bush. The pin positions determine the logic! From left to right, the function of each hole is: 1. Free 1. Connector 2. Stop bush 2. Empty 3. Empty 3. Empty 4. Empty 4. 0 5. 0 • 5. 1 • 6. 1 6. 0 • 7. 0 7. 1 8. 1 • 8. 0 • 9. 0 9. 1 10. 1 • 10. Not used (0) 11. 0 • 11. Not used (1) 12. 1 12. Empty 13. Empty 13. Empty 14. Empty 14. Stop bush 15. Connector 15. Free
Subassembly: Intermediate Rod for S (build 3)
Page 1 and 2: Rod Logic 1-bit Full Adder in LEGO
Page 3: Subassembly: Small Side Wall (build
Page 8: Turn it around for the next step.
Page 12: Axle pins on top, regular pins on t
Page 16: 1x Module Subassembly: 2x1 Module (
Page 20 and 21: 1x Module
Page 22 and 23: Beam here and on the back side.
Page 24: Axle pin Axle pin
Page 27 and 28: Subassembly: Input Rod B (build 1)
Page 30 and 31: This is the end to push. You could
Page 32: Axle pin Axle pin
Page 39: Subassembly: Intermediate Rod for S
Page 43: Subassembly: Intermediate Rod for C
Page 47: Subassembly: Output Rod (build 2)
Page 51: Subassembly: Short Side Stop (build
Page 59 and 60: 1x 2x1 Module Main Assembly: Full A
Page 61 and 62: 1x Input Rod B
Page 63: 2x Short Side Stop You might find i
Page 67 and 68: 1x Intermediate Rod for S/Cout
Page 69 and 70: 4x Long Side Stop You might find it
Page 71: 2x Short Side Stop

Rod Logic 1-bit Full Adder in LEGO - The Half-Baked Maker

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?