MDI Woodcarvers Supply

Gouges & Reciprocating Carver
Denny 5/16 inch “V” Gouge 52-516-VG $20.75
Denny 5/8” wide “V” gouge with 3” blade
designed by Pete Ortel 52-PO-VG $23.75
Skew Left
Long side on left
18
Skew Right
Long side on right
Warren Japanese Steel Tools
These tools are hardened to a Rockwell 64 for a
long lasting edge life and easy sharpening!
1.5mm “V” Tool
50-LV15 $7.25
3.0mm “V” Tool
50-LV30 $7.25
4.5mm “V” Tool
50-LV45 $7.25
1.5mm #8 Gouge
50-815 $7.25
Proxxon SGM Reciprocating Carver
Order Toll Free 800-866-5728
Denny 5/8” wide “V” gouge with 2” blade. Dave Stenson
modified Pete Ortel’s “V”-gouge saying the 2” blade gave
him better control, yet he switches back to the 3” “V”-gouge
when his knuckles don’t have enough clearance going around
corners. 52-DS-VG $23.75
Denny #3 Skew Bent Gouges with 4 1/2” Oak Handles
1/4” x #3 Skew Bent Left 52-25-3SGBL $22.25
1/4” x #3 Skew Bent Right 52-25-3SGBR $22.25
3/8” x #3 Skew Bent Left 52-38-3SGBL $22.25
3/8” x #3 Skew Bent Right 52-38-3SGBR $22.25
1/2” x #3 Skew Bent Left 52-50-3SGBL $22.25
1/2” x #3 Skew Bent Right 52-50-3SGBR $22.25
3.0mm #8 Gouge
50-830 $7.25
4.5mm #8 Gouge
50-845 $7.25
6mm #8 Gouge
50-860N $7.25
7.5mm #8 Gouge
50-875N $7.25
7.5mm Chisel
50-CH75N $7.25
9mm Shallow Gouge
50-SH9N $7.25
9mm #3 Gouge
50-390N $7.25
7.5mm Skew
50-SK75N $7.25
This quality German made unit features 11,000 cuts per minute, is 9.4 inches in length and weighs just 1.5 pounds without
blades. Casing is made from fiberglass reinforced polyamide with a cast aluminum gear housing. It contains multiple ball
bearings and thrust bearing. Three laminated steel gouges are included. It will also use the FlexCut RG series gouges featured
on the next page without any adapters. 25-SGM $135.00