PILATUS- ROLLER TURNING MACHINE - pilatus-ag.ch

More documents

Recommendations

Info

PILATUS M a s c h i n e n b a u A G The turning systems roller turning machine The SINGLE-POINT roller turning machine while turning with one cutting tool, with minimal material removal. Ideal for roller widths up to 2000 mm. The machining time of a roller width of 1000 mm is approx. 30 min. The TWIN roller turning machine while turning with two cutting tools, with minimal material removal. Ideal for roller width from 1200 mm on, but also suitable for smaller roller widths. This system has been developed to minimise the cutting time, i.e. the production breakdown. The machining time of a roller width of 1000 mm is approx. 15 min.
PILATUS M a s c h i n e n b a u A G roller turning machine Construction and method of construction 1. Prism- flat guideway 2. Motor 3. Operating light 4. Feed speed 5. Control system 6. Left/right switch 7. Centralized lubricating system 8. Scraper 9. V-Ledge 10. Handwheel 11. Machine bed 12. Stop switch 13. Handwheel 14. Cross slide 15. Advance feed control lever 16. Wing nut 17. Worm gearing 18. Lifting cog 19. Gear rack Slide The slide is guided on the machine bed (11) by a vee- and a flat guide (1). The guides are lubricated by the central lubrication system (7). To protect against wear to the guide surfaces and scrapers (8) remove adhering chips and dirt before processing. Infeed The infeed to the slide is moved lengthwise by means of a rack and pinion drive (19). The power for this is fed in by a handwheel (10) or an infeed motor (2) via cogwheels and a worm drive (17). By displacing the cog wheels (drive wheels) or the dog clutch, the infeed can be connected to operate manually or under power. After setting the lever switch (15) to "manual operation" the slide can be moved lengthwise by operating the handwheel (10). After setting the lever switch (15) to "power drive" the slide can be moved lenghtwise by means of the infeed motor (2). The lenghtwise travel of the slide is limited by the limit stop switch(12) and the lifting cog (18). Infeed motor The infeed motor (2) is fitted to a splined shaft, making it simple and rapid to remove. It is held in position by a wing nut (16). Control-system The control system (5) is easy to remove. It is plugged into the cross slide and is connected to the mains supply and the infeed motor by means of a rapid-release connection with stop switches (12). The operating light (3) shows when the machine is ready for use. The toggle switch (6) is used to set the rotational direction of the motor. The control knob (4) is turned to set the infeed speed. Cross slide The cross slide (14) is held in a swallow-tail guide. Its play is set by means of a V-ledge (9). Moving the cutter tool can be done by means of a threaded spindle and a handwheel (13.) There is a scaled ring by the handwheel (13) with a vernier scale. The cut can be read exactly by means of the scale marks.
Page 1 and 2: PILATUS- ROLLER TURNING MACHINE SWI
Page 3 and 4: PILATUS M a s c h i n e n b a u A G
Page 5: The types PILATUS M a s c h i n e n
Page 9 and 10: Substruction PILATUS M a s c h i n
Page 11 and 12: PILATUS M a s c h i n e n b a u A G

PILATUS- ROLLER TURNING MACHINE - pilatus-ag.ch

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?