Plastic - Water Tanks, Polyethylene Water Tank and Chemical Storage
Plastic - Water Tanks, Polyethylene Water Tank and Chemical Storage
Plastic - Water Tanks, Polyethylene Water Tank and Chemical Storage
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
30° CONE BOTTOM<br />
page 3 of 3<br />
CONE BOTTOM<br />
30° CLEARANCE<br />
TANK SIDEWALL CONE LEG LENGTH<br />
DIAMETER GAL./INCH CAP. (GALS.) (IN.)<br />
8’0” 31.3 470 34”<br />
9’0” 39.6 670 35”<br />
10’0” 48.9 910 42"<br />
STEEL PIPE LEGS<br />
30° cone bottom tanks are supported by steel pipe legs threaded into a fiberglass<br />
encapsulated steel leg ring. Legs must be ordered separately.<br />
LEG ORDERING INFORMATION<br />
To order legs, specify number required <strong>and</strong> overall length. Overall length is determined<br />
by adding amount of leg for 0” clearance (shown above) to desired clearance between<br />
the bottom of the cone <strong>and</strong> the floor.<br />
(NOTE: Raven recommends that clearance not exceed 24” unless specific<br />
application has been reviewed by the factory.)<br />
EXAMPLE: Legs for an 8’ diameter 6000 gallon tank (part #C38-6MC) with a<br />
24” clearance from bottom of cone to the floor would be ordered as follows:<br />
Number of legs required = 4<br />
Leg length = 0” clearance<br />
+ required clearance<br />
34”+24”<br />
Correct order would be (4) 58” tall legs.<br />
R A V E N<br />
Fiberglass encapsulated<br />
steel leg ring<br />
Welded steel coupling<br />
Welded steel<br />
coupling<br />
4" steel pipe,<br />
threaded both ends<br />
Steel pipe legs<br />
Threaded steel flange<br />
pad 150# ASA bolting<br />
geometry<br />
Fiberglass<br />
laminate
Change language