Operating Manual - GLAUNACH Vent Silencers
Operating Manual - GLAUNACH Vent Silencers
Operating Manual - GLAUNACH Vent Silencers
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
5.2 Connecting the vent silencer to pressure units<br />
The silencer has to be installed onto suitable connections. Forces, moments or<br />
vibrations on the connection shall be avoided. This includes also heat caused<br />
elongations of the pipe system during operation.<br />
Weldings has to be done according to the appropriate standards.<br />
Dewatering pipes have to be protected from freezing.<br />
(See also Glaunach Information Brochure: Information 7 „ Mounting“.)<br />
6. First Start-Up<br />
First Start-Up may take place if<br />
- the silencer was duly installed to the system<br />
- The installation instructions were obeyed<br />
- the silencer was controlled by qualified personell regarding mounting and<br />
connection<br />
The final release before first start-up has to be arranged by the operator of<br />
the vent silencer according to the national rules and regulations of the country of<br />
installation.<br />
7. OPERATION<br />
7.1 General<br />
The operator of the vent silencer has to take care that only instructed personnel<br />
will operate the silencer. The operator has to protect persons from any danger<br />
that a vent silencer may cause during operation.<br />
A safety zone around the silencer has to be considered. The operator must<br />
provide an appropriate operating instruction system, so that his personnel can<br />
be sufficiently advised.<br />
The operater of the silencer has to consider all national regulations of the<br />
country of installation according to vent silencers.<br />
7.2 Inappropriate use<br />
If the silencer was overloaded, e.g. from an unexpected reaction or as a result<br />
of inadmissible loads during the operation or if the silencer was damaged<br />
before, during or after operation, an special examination of the silencer has to<br />
take place.<br />
© 2005 <strong>GLAUNACH</strong> GMBH Edition 03.05<br />
Page 7 von 8