Instruction Handbook - TA Triumph-Adler
Instruction Handbook - TA Triumph-Adler
Instruction Handbook - TA Triumph-Adler
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Connections<br />
This section explains how to start up the printer.<br />
Connecting the USB Cable<br />
Follow the steps as below for connecting the USB cable.<br />
1 Connect the USB cable (not included) to the USB Interface<br />
Connector.<br />
Note Use a USB cable with a rectangular Type A plug and a<br />
square Type B plug. The USB cable should be shielded and<br />
no longer than 5 meters (16 feet) long.<br />
2 Connect the other end of the USB cable to the computer's USB<br />
interface connector.<br />
Connecting the Power Cord<br />
Install the printer close to an AC wall outlet. If an extension cord is used, the<br />
total length of the power cord plus extension should be 5 meters (16 feet) or<br />
less.<br />
Note Ensure the printer's power switch is off. Only use the power<br />
cord supplied with the printer.<br />
1 Connect the power cord to the Power Cord Connector at the rear of<br />
the printer.<br />
2 Connect the other end of the power cord to a power outlet.<br />
3 Press the Power Switch to On ( | ). The printer begins to warm up.<br />
IMPOR<strong>TA</strong>NT If you install the toner container and switch on the<br />
power, after a moment the indicators light in anticlockwise<br />
direction. When the printer is first switched on after toner<br />
installation, there will be a delay of approximately 15 minutes<br />
before the printer gets ready to print. Once the [Ready] indicator<br />
lights, printer installation is complete.<br />
3-2 Connecting and Printing
Change language