Catalog Volume 50 - Jenner Sales Corporation

www.jennersales.com 1-800-637-1692
8
NEW CONTINENTAL PRODUCTS
NEW 1-1/4” GLOBE VALVE ASSEMBLY WITH 2-
1/4” ACME EXTENSION COUPLING
A-216-L
Continental NH3 Products new 1-1/4” globe valve with 2-1/4” acme coupling has
finally arrived. We have taken our successful globe valve design and added a 2-1/4”
acme female by 1-1/4 male pipe threaded extension coupling to it for maximum flow
for 1-1/4” hoses. The bi-directional valve design allows you to put the coupling on
either side of the valve.
2-1/4” acme fitting for maximum flow
Long extension coupling
Knobs on the coupling makes gripping and
tightening easier
Coupling available separately “A-577-D”
and works with any 1-1/4” valve.
Dual 1/4" pipe ports on either side of the
hand wheel allows you to put a hydrostat if
needed
1-1/2” HIGH FLOW TOOL BAR COUPLER
Continental NH3 Products all new A-HFC-112-G, 1-1/2” tool bar coupler is specifically designed for high flow cold weather application. It’s
40 percent larger than a 1-1/4” model and when used in conjunction with 1-1/2” hoses, valves and couplings you can achieve flow increase
of up to 50 percent. It incorporates our proven locking collet design with easy reconnection, dual bleeder valves, stainless steel
check valves, guides and springs as well as 2 additional 1/4" pipe thread ports for hydrostatic relief valves when needed. If you are looking
for more capacity and faster speeds in cold weather then our new line of 1-1/2” equipment is the way to go. Dollar for dollar this is the
biggest bang for your buck you will find. With new pumping systems costing over $5000.00 you can achieve similar flow rates for far less
money.
Up to 50 percent flow increases when using 1-1/2”
equipment
40 percent larger than 1-1/4” model
Bleeder valves included
Less investment than pumping systems
Traditional design with proven locking collet system
ORDER ONLINE AT www.boomersprayparts.com