DWFG725L User Manual - Appliances Online
DWFG725L User Manual - Appliances Online
DWFG725L User Manual - Appliances Online
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Setting up your dishwasher<br />
STEP3. Connecting the hoses and powering<br />
Max. 80 cm<br />
14_ Setting up your dishwasher<br />
Min.<br />
30 cm<br />
Max.<br />
80 cm<br />
1. Remove the hose holder which is attached to the product and cut off part of the holder as shown in the<br />
fi gure.<br />
2. Discard the part you have just cut off and use only the part that is shown by the fi gure.<br />
3. Fix it to the wall by fastening the 2 screws.<br />
4. Insert the drain hose into the fi xed hose holder.<br />
Install the drain hose so that it is placed within a range of 30 cm to 80 cm from the bottom.<br />
5. Connect the drain hose to the drain outlet.<br />
• Take care when you connect the drain hose that it does not move during a draining cycle.<br />
CAUTION • Confi rm that no parts of the drain hose, supply hose or power cord are bent or folded.<br />
6. Open the door and remove all foam, paper packaging, and unnecessary parts.<br />
7. Turn on the circuit breaker you turned off before you began the installation.<br />
8. Open the water supply valve to supply water to the dishwasher.<br />
9. Turn on the dishwasher, and then select and run a cycle.<br />
Check if the power turns on correctly and if there is any water leakage while the dishwasher is<br />
operating. If no errors occur while it is operating, turn off the dishwasher, and then go to No.5 of<br />
above.<br />
If an error has occurred, turn off the dishwasher, close the water supply valve, and then refer to the<br />
user manual or contact a service centre as referring to the contact list on the back cover.<br />
Make sure to check for water leakage on both ends of the water supply line and drain hose<br />
CAUTION connector.<br />
DD68-00093B_EN-AU.indd 14 11/23/2011 10:54:41 PM