Presentation - Power Integrity Analysis in a split plane PCB

17.10.2012 • Views

Share Embed Flag

Presentation - Power Integrity Analysis in a split plane PCB

Presentation - Power Integrity Analysis in a split plane PCB

DOWNLOAD ePAPER

ansoft

Create successful ePaper yourself

Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.

START NOW

Bare 1.8v <strong>split</strong> <strong>plane</strong> resonance

An Advanced Methodology for On-chip Passive Component

Utilizing LVDS to Reduce EMI/EMC in Network Cameras

Presentation - Design of 3D Integrated LTCC Antenna Switch ...

Advanced Power Amplifier Design Using Doherty Configurations

Presentation - Behavioral Modeling of a 4 Phase Buck Converter ...

PCB Radiated Emissions Linked With Enclosure

Bessel Filter Design

Simulation for Fuel Cell Inverter using Simplorer and Simulink

Simplorer 6.0 Product Preview

Sea Ceramics Technologies

Accurate and Accurate and Efficient SSN Modeling

DesignCon 2002

Application of HFSS for Predicting and Eliminating Enclosure ...

A Few Personal Remarks on the Evolution of

Training Seminar for Maxwell 2D v10 & RMxprt v5

Bare 1.8v <strong>split</strong> <strong>plane</strong> resonance

Bare 2.5v <strong>split</strong> <strong>plane</strong> resonance

Page 1 and 2: Power Integrity Analysis in a split
Page 3 and 4: New trend in high speed design: Pow
Page 5 and 6: Lower voltage, split planes, poor s
Page 7 and 8: Engineers used to depend on experie
Page 9 and 10: SIwave for Power Integrity SIwave c
Page 11: A ten-layer PCB with split power pl
Page 15 and 16: Mesh is dense in sensitive areas
Page 17 and 18: No resonance observed up to 350Mhz
Page 19 and 20: Small voltage fluctuation in 10MHZ
Page 21 and 22: Some local voltage fluctuation in 3
Page 23 and 24: Three 100uf caps added to reduce fl
Page 25 and 26: Resonance induced
Page 27 and 28: Z parameter vs. frequency at probe
Page 29 and 30: Add probe and port for plane crosst
Page 31 and 32: S parameter for split plane crossta
Page 33: Thanks a lot!