Franklin 4 6 And 8 in Submersible Motors

Special Options
6” Submersible Motors Standard
Applications
These motors are built for dependable operation in
6” diameter or larger water wells.
Basic Features
■ Full 3450 RPM, 60 Hz Design Point
■ Maximum Temperature Winding Wire NEMA
Class 200
■ Double Flange Design
■ Stainless Steel Splined Shaft
■ Hermetically-sealed Stator
■ Resin Encapsulated Windings
■ Stainless Steel Shell
■ Epoxy Coated End Frames
■ Filter Check Valve
■ Kingsbury-type Water-lubricated Thrust Bearing
■ Pressure-equalizing Diaphragm
■ 3-Lead & 6-Lead (Wye-delta) Confi gurations
■ Pre-fi lled with Temperature-resistant Fill Solution
■ Sand Fighting Slinger
■ Removable Water Bloc Lead
■ Copper Bar Rotor
■ Carbon Ceramic Rotating Face Seal
■ Franklin-manufactured Control Boxes Available
for Single-Phase Motors
■ Worldwide Availability
■ Sand Fighter Models with special Silicon Carbide based sealing system available for applications with
sand or other abrasives.
■ 316 SS Construction available. All 316 SS motors include Sand Fighter sealing system and Subtrol Heat
Sensor for use with SubMonitor protective devices.
■ NiResist Construction available. All NiResist motors include a Sand Fighter sealing system and Subtrol Heat
Sensor for use with SubMonitor protective devices.
■ SubMonitor Motor Protection — A fi eld proven and contractor friendly premium motor protection system.
It protects the motor against overload, underload, overheating, and rapid cycling. The use of SubMonitor
can also extend the motor warranty (see SubMonitor literature for details).
NOTE: Motor must be manufactured with Subtrol Heat Sensor.
21