TCP/IP Connectivity Utilities for i5/OS commands - IBM

Change REXEC Attributes (CHGRXCA)
Where allowed to run: All environments (*ALL)
Threadsafe: No
Parameters
Examples
Error messages
The Change REXEC Attributes (CHGRXCA) command changes the configuration of the TCP/IP Remote
Execution (REXEC) servers. You can change REXEC attributes when REXEC servers are active. Changes
take effect the next time an REXEC server connection is made. Existing connections are not changed, but
keep the attributes they had when the connection was established.
Restrictions:
v You must have input/output system configuration (*IOSYSCFG) special authority to use this
command.
Parameters
Keyword Description Choices Notes
AUTOSTART Autostart servers *YES, *NO, *SAME Optional,
Positional 1
NBRSVR Number of initial servers 1-20, *SAME, *DFT Optional
INACTTIMO Inactivity timeout 1-2147483647, *SAME, *DFT Optional
CCSID Coded character set
identifier
Autostart servers (AUTOSTART)
1-65533, *SAME, *DFT Optional
Specifies whether to automatically start the REXEC servers when TCP/IP is started by the Start TCP/IP
(STRTCP) command or STRTCPSVR SERVER(*AUTOSTART) command. When REXEC is started by the
Start TCP/IP Server (STRTCPSVR) command, and SERVER(*AUTOSTART) is omitted, this parameter is
ignored and the number of servers defined is started regardless of the value of this parameter.
*SAME
The autostart value that was previously set does not change; otherwise, *NO is used.
*NO Do not start the number of servers defined in the NBRSVR parameter when the STRTCP
command is called. If you do not plan to use REXEC, set AUTOSTART to *NO.
*YES Start the number of servers defined in the NBRSVR parameter.
© Copyright IBM Corp. 1998, 2008 33
Top
Top
Top