Heligun EX17.pdf - Forgotten Weapons
Heligun EX17.pdf - Forgotten Weapons
Heligun EX17.pdf - Forgotten Weapons
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
HTC-AD 66-21<br />
2. l. 3 Remove Loader Assembly from Receiver Assembly by<br />
unscrewing the two CA 4600-4 screws. Screws need not<br />
be removed from Loader Assembly. Screws are self<br />
locking and cannot be loosened unless pin in center of<br />
slot is depressed (Figure !0).<br />
2. 1. 4 The Receiver is not normally disassembled during over<br />
haul. If disassen1bly is desired, the following procedure<br />
may be followed.<br />
2. 1. 4. 1 Push out pin joining cover to receiver. This pin<br />
has a flat side against which the cam follower<br />
brake spring seats. Remove brake spring and<br />
block {Figure 1 0).<br />
2. 1. 4. 2 Push out rocker arm pin and remove rocker arm<br />
and cam fol1owers (Figure 1 O).<br />
2. 1. 4. 3 The Eject Chutes are pressed in. The other<br />
parts are sequentially retained by the snap ring<br />
at aft end of auxiliary Firing Pin Guide.<br />
CAM FOLLOWER BRAKE<br />
Figure 10<br />
16