1 Safety instructions 2 Device components KNX/EIB - Gira
1 Safety instructions 2 Device components KNX/EIB - Gira
1 Safety instructions 2 Device components KNX/EIB - Gira
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>KNX</strong>/<strong>EIB</strong><br />
Weather station Standard<br />
CAUTION!<br />
The angular arm (2) may break when the terminal box is closed.<br />
The device can be damaged!<br />
The angular arm must not be used as a lever and pulled downwards.<br />
o Set device on lower part of terminal box from above and snap in at bottom.<br />
Aligning the device<br />
Figure 5<br />
o Orient sensor head using a compass in such a way that the bevelled surface and<br />
brightness sensor 2 (Figure 5) point south.<br />
i Without correct orientation the brightness sensors will not be assigned to the compass<br />
directions. The arrangement of the brightness sensor – seen from above – is shown in<br />
Figure 3.<br />
i In some circumstances it may be advisable to orient the device according to the specific<br />
local conditions, e.g. according to the facades. Geographical features may also necessitate<br />
a different orientation.<br />
Dismantling the device<br />
o Insert screwdriver into the notch on the underside of the terminal box and carefully lever<br />
the device upwards.<br />
o Remove sensor connector from sensor terminal (5).<br />
82562822 12.06.2012 4/6