PROFIBUS DP Slave (Protocol API, netX)

Introduction 6/228
1.2 List of Revisions
Rev Date Name Chapter Revision
9 2009-04-16 RG Firmware/stack version V2.2.20.
Added descriptions of packets for auto config and static diagnostic.
Added one error code description.
10 2010-05-12 RG/HH Section PROFIBUS_FSPMS_CMD_STATE_CHANGED_IND – Indication for
Change of State completely rewritten
Extended section on task structure with descriptions of single tasks.
Added information of suitability of packets for LFW or LOM approach.
Corrected Configuration Data in Table 32: Meaning and allowed Values for
Warmstart-Parameters.
Section Technical Data: DMA support for PCI targets, Slot number added
Firmware/stack version V2.3.x.
Reference to netX Dual-Port Memory Interface Manual Revision 9.
11 2010-10-29 RG/RH Firmware/stack version V2.3.32.x
Added description of 2 new flags in Warm-Start Parameters
12 2012-01-26 RG/FM/
HH/MPr
Firmware/stack version V2.4.12.x
Reference to netX Dual-Port Memory Interface Manual Revision 12.
Description of 3 I&M packets added
Added section 6.3“Hardware Switches for the Adjustment of Slave Address
and Baudrate”. Adapted description of system flags accordingly.
Adapted section “Cyclic Data (Input/Output Data)” for netX devices with 8
kByte Dual-port Memory.
abCfgData in warmstart packet is 244, not 32
Corrections in Identifier Byte for the General Format, Identifier Byte for the
Special Format, Length Byte and Reason Code.
Correction of structure name
PROFIBUS_APS_PACKET_SET_CONFIGURATION_REQ_T
Removed data part of packet in section 6.2.3
Update of section “References”
Update of section “Technical Data” due to change in limitations (I & M)
Update of “Contacts” chapter
Table 1: List of Revisions
PROFIBUS-DP Slave | Protocol API
DOC050401API12EN | Revision 12 | English | 2012-01 | Released | Public © Hilscher, 2005-2012