Cannabis Grow Bible.pdf - the DMT-Nexus

292
_________________________________________________________________________________________
tackle some dead leaves or leaves that have
some mould build up on them. Mould looks like a
rust or fluff on the leaves and will most of
the time spread to other parts of the plant. So
why not cut these away too while you thin your
grow area.
Thinning your grow makes it look nicer and
tidier and helps to improve your overall yield.
Light Bending:
Light bending occurs when a plant tries to
grow at an angle towards the light. You may
have seen some of the outside plants in your
grow area bending towards the light to try and
get their share. If your plants bend too much
they will eventually grow towards (or even
into) another plant. This is not good as they
will cover other plants. Also during flowering
the buds can get heavy and may cause your plant
and pot to fall over. To avoid light bending
simply switch your plants around from day to
day. If a plant leans too much one way, then
take it towards the middle of the pack or turn
the plant around. It only takes a day or two
for the plant to bend back straight again. If
your plants can not be moved, such as in the