OM, Soff-Cut 4200, 2010-01, EN - Klippo
OM, Soff-Cut 4200, 2010-01, EN - Klippo
OM, Soff-Cut 4200, 2010-01, EN - Klippo
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Content<br />
CONT<strong>EN</strong>TS<br />
Page<br />
Table of contents ………………………….. 2<br />
Unpacking .................................................. 2<br />
Transporting ............................................... 2<br />
Sound Data ................................................ 2<br />
Introduction, personal safety ...................... 3<br />
Registration of the product ………………… 4<br />
General safety message ............................ 4<br />
Safety warnings ......................................... 5<br />
Excel series blades ................................... 6<br />
Blade and skid plate installation ................ 6<br />
What is what? ............................................ 7<br />
Operating instructions ............................... 8-9<br />
Fuel and fuel safety warnings …….…….... 10<br />
Recommended fuels ................................. 10<br />
Recommended oils …….......……….…..… 10<br />
Engine and transmission maintenance ..... 11<br />
Other maintenance ………………….…….. 12<br />
Sawing contraction joints …………....….… 13<br />
Maximizing the <strong>Soff</strong>-<strong>Cut</strong> system .......…..... 14<br />
Troubleshooting ......................................... 15<br />
Your <strong>4200</strong> saw has been shipped from the factory thoroughly<br />
inspected. Only minimal assembly is required to start using<br />
the saw. Remove the saw from the container using proper lifting<br />
techniques. Discard or recycle the packing material per<br />
your regional laws. In your container will be the <strong>4200</strong> saw,<br />
diamond blade, skid plate, blade shaft wrench, spark plug<br />
wrench, an owner’s manual, an engine owner’s manual, a part<br />
list, a warranty card, a joint protector sample pack and a ramp<br />
for unloading the saw. Connect the battery cables and turn the<br />
key switch to the “ON” or “1” position on the instrument panel.<br />
Press the rocker switch on the instrument panel to raise the<br />
saw. Place the unloading ramp at the edge of the container<br />
and roll the saw out of the container. Lower the saw and turn<br />
the key switch to the “OFF” or “0” position.<br />
The <strong>4200</strong> saw weights approximately 496 pounds (225 kilograms)<br />
when ready to use . Use safe lifting practices when<br />
handling the saw. Always remove the diamond blade when<br />
transporting the saw. Always transport the saw with a skid<br />
plate installed. Retract the guide arm. The saw can be lifted<br />
from the side and front handles or using the optional lifting kit<br />
and sling. Always store and transport the saw in a completely<br />
lowered position and secured from moving.<br />
Instrument<br />
panel<br />
UNPACKING<br />
TRANSPORTING<br />
Lifting point<br />
Hood<br />
Lifting point<br />
Technical specifications ............................. 16<br />
Conformity certificates ............................... 16<br />
Warranty .................................................... 17<br />
Front guide<br />
Lifting point<br />
CAUTION<br />
Only use the side and front lifting<br />
handles when lifting the <strong>4200</strong>.<br />
2