Bindings - Rasc.ru

RENTAL
The rental department is often a great profit center for most shops and so it is important
that we focus on ensuring the Rossignol rental equipment operates problem free. For a
multitude of reasons the process of mounting of rental equipment is often rushed
through without much thought of the consequences.
We would like to take a few minutes to review some important mounting information of
Rossignol rental skis. The rental shop manager can reduce the risk of mounting problems
following these guidelines.
Don’t rush through the process. The average
rental ski is in use for three seasons. A
few extra minutes in the mounting process
is immaterial to the overall shop profits.
Be sure to use the correct template.
Tape over or plug the bushings that will
not be used.
If mounting a Rossignol Speedset binding
set the template to 290 mm.
Check that the template sits flush on the
ski.
Use a new 4.1 x 9 mm drill bit (4.1 x 9.5 or
4.1 x 10 mm is also acceptable) including
Edge and Roc X-120, 130 cm. skis. (Check
the information window on the ski)
A word of caution: When mounting other
manufacturers rental bindings on shorter
length Rossignol rental ski, be sure to
check the ski will accept the drill depths
before drilling.
Also, if using a larger template setting be
sure to check the drill bit depth before
drilling.
Drill deep enough to deburr the top
skin of the ski.
Remove debris from the holes.
Use SKI BINDING glue. Ski binding glue
can be purchased from any binding manufacturer.
Do not use white glue or wood
glue.
Insert the screws with a maximum 5 Nm. of
torque. If using a screw shooter pull the
trigger intermittently. Screws can be partially
stripped without the screw spinning.
Test mount one ski and confirm a selection
of boot sizes.
23