Series7

auto select
reset
high
low
empty
high
low
empty
washable
high
low
empty
start
fast clean
cleaning
start
fast clean
cleaning
clean
eco
cleaning
normal
intensive
clean
eco
normal
intensive
auto select
clean
eco
high
low
empty
start
cleaning
fast clean
clean
eco
normal
intensive
Before shaving
Prior to first use you must connect the shaver to
an electrical outlet using the special cord set i
or alternatively proceed as below.
normal
intensive
eco
clean
Installing the Clean&Renew station
• Using the special cord set i, connect the
station power socket 6 to an electrical outlet.
• Press the lift button 2 to open the housing.
start
normal
intensive
• Hold the cleaning cartridge 7 down on a flat,
stable surface (e.g. table).
• Carefully remove the lid from the cartridge.
1
2
auto select
new
• Slide the cartridge into the base of the station
as far as it will go.
auto select
auto select
• Slowly close the housing by pushing it down
until it locks.
The cleaning fluid display 1 will show how much
fluid is in the cartridge:
high
high
high
«high» up to 30 cleaning cycles available
«low» up to 7 cleaning cycles remaining
«empty» new cartridge required
low
empty
low
empty
low
empty
Charging and cleaning the shaver
Insert the shaver head down into the cleaning
station. (The contacts t on the back of the
shaver will align with the contacts 3 in the
cleaning station).
trimmer
If required, the Clean&Renew station will now
charge the shaver. The hygiene status of the
shaver will also be analyzed and one of the
following cleaning program diodes 5 will light
up:
«clean» shaver is clean
«eco» short economical cleaning required
«normal» normal level of cleaning required
«intensive» high intensive cleaning required
start
cleaning
clean
eco
normal
intensive
auto select
5