View TSDS - Nippon Paint Malaysia
View TSDS - Nippon Paint Malaysia
View TSDS - Nippon Paint Malaysia
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Composition:<br />
Pigments<br />
Binder<br />
Thinner<br />
Properties:<br />
Colour<br />
Appearance<br />
Recommended no. of coats<br />
Recommended Dry Film<br />
Thickness Per Coat<br />
Dilution<br />
Drying Time<br />
Touch Dry<br />
Recoating Interval<br />
Theoretical Coverage at<br />
Recommended Dry Film<br />
Thickness<br />
:<br />
:<br />
:<br />
:<br />
:<br />
:<br />
:<br />
:<br />
:<br />
:<br />
:<br />
Mainly Titanium Dioxide, Iron Oxide, Carbon Black and<br />
Organic Pigments and Mineral Extender<br />
Modified Acrylic Polymer Emulsion<br />
Water<br />
A wide range of colours. Please refer to colour card.<br />
Soft Mat finish<br />
2-3 coats<br />
Around 30 µm (Dependent on the substrate condition)<br />
The paint is ready for use after thorough stirring.<br />
If necessary, dilute with maximum 5% water.<br />
Minimum 30 minutes at 30°C<br />
2-3 hours minimum based on normal condition<br />
10 m² per litre per coat (35 micron DFT)<br />
(Actual coverage is dependent on substrate condition.) *<br />
Application Methods:<br />
1) Brush / Roller : By brush or roller<br />
For better finishing, it is advisable to apply using roller<br />
application follow by trim with brush<br />
Clean Up : Clean up equipment with water immediately after use.<br />
Surface Preparation:<br />
WOOD<br />
Wood must be dry and free from dirt, grease and other contaminants. Smoothen surface with<br />
sandpaper and then clean off and dry.<br />
METAL<br />
Surface must be dry and free from dirt, grease and other contaminants. Ferrous substrate should be<br />
sanded or wire-brushed to remove millscales and rust. Clean off dust and dry.<br />
Previously <strong>Paint</strong>ed Surfaces<br />
Any loose and flaking paint film must be scrapped off. Defective areas should be sanded and<br />
smoothened. The entire surface must finally be dry and clean of dirt, grease and other contaminants.<br />
Make good any surface defects, clean off and dry. In the case of ferrous substrates, rust should be<br />
thoroughly removed. The scraped areas should be spot-primed using NIPPON HYDROPRIME for<br />
metal and wood surfaces.<br />
NP HG Page 2 of 4<br />
Feb-10 VERSION