TP 270 PTO - Woodchippers

TECHNICAL DATA
Max wood diameter
Max opening
Operation
Chipper principle
EXTRA EQUIPMENT
270 mm
H x W = 270 x 290 mm
Return/forward/stop of feed rollers through operating bar (yellow)
Disc
In feed angle 45°
Feeding angle
In feed
Feed rollers
Rotordisc - diameter
Rotordisc - Weight in kg 274
Number of knives
Chip lenght
Anvil/Counter steel
Sliverbreakers
Power required
PTO rpm
PTO shaft
45 ° slanting backwards to driving direction
2 hydraulic feed rollers
Vertically
960 mm
3 pcs.
12-22 mm
3-point linkage Category 2
Chip capacity
Max allowable pressure on coupling
Weight
Stress control system
Extended ejector spout
Tip-up ejector spout
Sliverbreakers
Light bar
Winch
Tool kit
1 horisontal and 1 vertical
Type A - Max. opening lxb = 55x30mm
80-150 kW (100-200 hp)
540 rpm or 1.000 rpm/min.
Walterscheid P500 series with freewheel, length = 710 mm
20-25 m 3 /hour (Experience numbers by manuel operation)
500 kg
1385 kg
For protection of the engine of the tractor by monitoring the rpm on the rotor
disc
500 mm vertical • 1.500 mm horisontal • Extended ejector spout across
the tractor 3.700 mm, Height 2230 mm
Type B - are used if extra requirements for chip quality is needed
Opening max. 55x17 mm
Light bar with complete set of rear lights
For wood feeding - the winch is towed by the wood chippers hydraulic system
Includes tools for daily service and maintenance
Linddana A/S
Ølholm Bygade 70 · DK-7160 Tørring
Tlf +45 75 80 52 00 · Fax +45 75 80 54 11
e-mail tp@linddana.dk · www.tp.dk