Assembly Instructions page 1 Siena Chaise Lounge ... - Oxford Garden

Assembly Instructions page 2
Step 1
On a clean flat surface, lay chaise lounge frame 6 flat on its back.
Apply the glue provided in the mortise holes on the back rail 5 and the
tenons on the chaise frame as shown.
GLUING INSTRUCTIONS:
Correct assembly of this lounge requires glue to be applied to the final
assembly joints using the supplied glue. To properly glue these
joints follow the directions below:
a. Lay the assembly part flat and apply a liberal amount of glue into
the mortise using the brush and glue supplied. Use the brush to
make sure the glue is thick on the inside walls of the mortise and has
made contact with the entire tenon.
b. Assemble the parts as instructed in the instruction steps. After
assembling the glued parts, use a damp cloth or sponge to clean
up any excess glue from the outer surface of the furniture.
Step 2
Once you have applied the glue, insert the back rail into the the
chaise frame and secure by driving 2 long dowels G into the
back rail as shown.
G
G
Siena Chaise Lounge
Step 4
Align the right arm assembly 1 to the chaise lounge frame by attaching
the front section of the arm to the large arm dowel and attach the back
leg section of the arm to the rear tenon of the chaise lounge frame.
NOTE: You may need to turn the chaise frame on its side to attach the
arms or prop the head of the chaise to attach the arms.
1
Wood Glue
Step 3
Wood Glue
Insert the arm dowel 3 but do not attach it yet.
5
6
3