CFD Modeling Of Water Vapor Fogging and Defogging ... - ESSS

More documents

Recommendations

Info

Results - Evaporation Temperature at the Internal Surface of the Lens
Conclusion and next steps. • The CFD simulation were capable to represent the three steps of the automotive headlamps condensation test: heating, condensation and evaporation. • Some boundary conditions: heating time and water temperature, must be adjusted to simulated better the most severe conditions that could be found during the vehicle life. • Will be necessary modify the actual condensation standard test to achieve a better correlation between physical test and CFD simulation.
Page 1 and 2: CFD Modeling Of Water Vapor Fogging
Page 3 and 4: Company Overview Foundation Date: 1
Page 5 and 6: Methodology • Code: ANSYS FLUENT
Page 7 and 8: Results - Heating Temperature on th
Page 9 and 10: Results - Heating Relative Humidity
Page 11 and 12: Results - Heating Air get into the
Page 13 and 14: Results - Condensation Temperature
Page 15: Results - Evaporation The water fil

CFD Modeling Of Water Vapor Fogging and Defogging ... - ESSS

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?