Lobo Catalogue - Lighthouse Safety, LLC

instructions
LIFTING SLIDER FRAME
1. Slide the ends of the lifting beam into the top
clamps and fully tighten.
2. Extend the telescopic leg inserts on the trestle
legs to the desired height, insert height
adjustment pins and tighten the thumb screws.
3. Fit the ends of the sway braces into the clamps
on the top of the beam.
4. Swing the bottom ends of the sway braces out
and using Lobands, clamp them to the trestle
legs.
5. Check that the clamps in use are fully tightened.
6. Outriggers can be used to add extra stability,
if necessary.
Lifting slider
frame
LIFTING FRAME
1. Slide the ends of the lifting beam into the top
clamps and tighten the clamp.
2. Extend the telescopic leg inserts on the trestle
legs to the desired height, insert height
adjustment pins and tighten the thumb screws.
3. Using Lobands, position the sway braces in
position with the Lobands on the legs just
above the upper leg clamps.
4. Check that all clamps in use are fully tightened.
5. Outriggers can be used to add extra stability,
if necessary.
Lifting frame
22
Lobo Systems Ltd, Riverside Park, Raynesway, Derby DE21 7RW, UK www.lobosystems.com tel: +44 (0)1332 680028 fax: +44 (0)1332 668068