15 690 - Boston Gear

FLANGED REDUCER ASSEMBLIES AND MOUNTING POSITIONS
ASSEMBLIES - F/QC 700 Series
A
Standard assemblies define output shaft (slow speed)
projection with respect to input shaft (high speed) and
mounting surface.
Types “A” and “B” are horizontal bases.
Types “C” and “E” are vertical high bases and Types “D”
and “F” are vertical low bases. Type “X” is input vertical
up.
BASIC
UNIT
TYPE
A
TYPE
B
G* H J
J* H G
G* H
J
Basic models and separate base kits are supplied
unless otherwise specified. Assembly “H” is available at
a slight additional charge.
TYPE
C & D
J* H
G
See Page 14 for complete ordering instructions.
Input may rotate clockwise or counter clockwise.
TYPE
E & F
G* H J
FOR OTHER CONFIGURATIONS NOT SHOWN,
CONTACT FACTORY.
TYPE
X
G* H J
* Standard assemblies
MOUNTING POSITIONS - F/QC - SF - HF/HQC 700 Series
Standard assemblies are for Position 1. The design permits
any type of assembly to be mounted in any position
shown by the proper location of the vented oil filler, level
and drain plugs, at the time of installation.
For other than Position 1, order standard and relocate
vented oil filler, level and drain plugs.
For production orders Boston Gear will assemble units
for the specified mounting position desired at no additional
charge.
MOTOR HORIZONTAL
4
FLOOR
•
MOTOR
HORIZONTAL
FLOOR 2
FLOOR
1
•
3
•
FLOOR
MOTOR VERTICAL
CAUTION
When ordering speed reducers pre-lubricated,
the Mounting Position must be indicated to
ensure proper oil level.
5
•
FLOOR
•
This position is
not recommended.
6
•
• Indicates proper oil level.
16 700 Series