Dorado Pro Service Manual - Manitou

11. Replace O-ring #064962 on the threaded
end of the compression rod shaft. (FIG. 19)
12. Insert poppet into compression rod shaft.
(FIG . 20)
13. Insert poppet spring into air piston and
thread into compression rod shaft. (FIG. 21)
Tighten air piston to 45-55 in lbs [5.1 - 6.2 Nm]
14. Insert a 2.5mm Allen wrench into the
center of the air piston and push lightly until you
feel it engage on the poppet. (FIG. 22) Turn the
poppet clockwise, threading it onto the valve
shaft. Tighten it until the valve shaft protrudes
from the valve housing 1mm. (FIG. 23)
FIG. 21
FIG. 19
FIG. 22
FIG. 20
FIG. 23
19
SERVICE MANUAL