Autosar conformance testing using TTCN-3

More documents

Recommendations

Info

Conformance Testing Methodology Test scope Interfaces, behavior and configurations Functional tests of individual basic software modules Requirements on tests Tests case specifications shall be stringent, accurate and non ambiguous Executable test procedures shall be derived automatically from tests specifications 28
Rationale for choosing TTCN-3 for test specifications TTCN-3 is used for dynamic tests Abstract notation for test specifications and stubs Tests procedures can automatically be derived from test specifications Test specifications delivered to CTAs by AUTOSAR are non ambiguous Test suites developed by CTAs will keep the same behaviour. Boundary conditions The tooling available on the market should behave the same wrt the TTCN- 3 notation TTCN-3 rules had to be elaborated in order to fit to the tools capabilities 29
Page 1 and 2: AUTOSAR conformance testing using T
Page 3 and 4: Introduction AUTOSAR, AUTomotive O
Page 5 and 6: AUTOSAR has standardized the softwa
Page 7 and 8: Development Approach: 2004-2008 Obj
Page 9 and 10: AUTOSAR Main Working Topics Archite
Page 11 and 12: Architecture en couches Application
Page 13 and 14: AUTOSAR Méthodology (1/2) Sofware
Page 15 and 16: Application Interfaces WPII-10.1 Bo
Page 17 and 18: Integrated Master Table as Engineer
Page 19 and 20: Major Achievements of Releases 3.0/
Page 21 and 22: Conformance testing in the AUTOSAR
Page 23 and 24: Conformance Testing for AUTOSAR pro
Page 25 and 26: Conformance Test Specification proc
Page 27: Conformance Test Methodology Check
Page 31 and 32: Outcome from the CTSpecs project A
Page 33: Thank you for your attention! http:

Autosar conformance testing using TTCN-3

Create successful ePaper yourself

Delete template?

Save as template?