Safety data sheet - Stehlin Hostag UK

34.0.12
Safety data sheet
according to 1907/2006/EC, Article 31
Page 4/8
Printing date 05.06.2012 Version number 4
Revision: 05.06.2012
Trade name: NewV lac gloss 60UC1100
(Contd. of page 3)
SECTION 6: Accidental release measures
· Personal precautions, protective equipment and emergency procedures Ventilate the area.
· Environmental precautions:
Do not allow to enter drains. If the product contaminates rivers and lakes or sewers inform respective
authorities.
· Methods and material for containment and cleaning up:
Contain and collect spillage with non-combustible absorbent material, (e.g. sand, earth, diatomaceous
earth, vermiculite) and place in container for disposal according to local regulations. Clean preferably with a
detergent. Avoid use of solvents.
· Reference to other sections
See Section 7 for information on safe handling
See Section 8 for information on personal protection equipment.
See Section 13 for information on disposal.
SECTION 7: Handling and storage
· Handling
· Precautions for safe handling
Avoid inhalation of vapour. Smoking, eating and drinking should be prohibited in application area. For
personal protection see Section 8. Comply with health and safety at work laws. Avoid concentrations higher
than the occupational exposure limits (see Section 8), if applicable.
· Conditions for safe storage, including any incompatibilities
· Storage
· Requirements to be met by storerooms and containers:
Keep container tightly closed.No smoking.
Containers which are opened must be carefully resealed and kept upright to prevent leakage.
· Further information about storage conditions:
Always keep in containers of the same material as the original one. Store in a dry, well ventilated place.
Keep away from heat and direct sunlight. Store in accordance with the particular national regulations
concerning water pollution.
Noudatettava etiketin ohjeita.
· Specific end use(s) No further relevant information available.
SECTION 8: Exposure controls/personal protection
· Additional information about design of technical systems:
If relevant apply technical measures to comply with the occupational exposure limits. This can be achieved
by a good general extraction and - if practically feasible - by the use of a local exhaust ventilation.
· Exposure controls
· Personal protective equipment
· Protection of hands:
For prolonged or repeated contact use gloves.
Barrier creams may help to protect the exposed areas of the skin, they should however not be applied once
exposure has occurred.
(Contd. on page 5)