Electronic Hand Stimulator And Massager

More documents

Recommendations

Info

Battery information Caution: 1. Please use SxAAA batteries in this unit. 2. Remove the batteries if the device is not in use for long periods of time. 3. Do not mix old and new batteries or different types of batteries. 4. Warning: If batteries leak and come into contact with the skin or eyes, wash immediately with copious amounts of water. 5. Batteries must be handled by an adult. Keep batteries out of the reach of children. 6. Only batteries of the same or equivalent type are recommended. 7. Do not use rechargeable batteries. 8. Remove exhausted batteries from the unit. 9. Supply terminals are not to be short circuited. 10. Dispose of batteries safety according to battery manufacturer's instructions. Therapeutic modes The PM-775 offers 15 therapeutic modes as a cycle. The fixed frequency is 1 KHz and the pulse duration is 300(js. The total treatment time is around 30 minutes. No. P1 P2 P3 P4 P5 Program parameters Rate=10Hz Working time=3.2s Pause time=1 .Os Rate=12.5Hz Working time=7.0s Pause time=1.0s Rate=20Hz Working time=4.5s Pause time=1.0s Burst Rate=50Hz Working time=5.5s Pause time=1.0s Rate=15Hz Working time=4.5s Pause time=1.0s No. P6 P7 P8 P9 P10 Program parameters Rate=15Hz Working time=4.7s Pause time=1 ,0s Rate=20Hz Working time=2.2s Pause time=1 .Os Rate=12.5Hz Working time=4.3s Pause time=1.0s Burst Rate=40Hz Working time=5.5s Pause time=1.0s Rate=20Hz Working time=8.3s Pause time=1.0s No. P11 P12 P13 P14 P15 Program parameters Rate=20Hz Working time=2.2s Pause time=1.0s Rate=20Hz Working time=5.6s Pause time=1 .Os Rate=15Hz Working time=4.6s Pause time=1.0s Rate=20Hz Working time=4.2s Pause time=1.0s Rate=20Hz Working time=4.86s Pause time=1 ,0s 16 17
Specification Power Sources: 4.5V DC, 3xAAA batteries Frequency: 10Hz~50Hz Pulse Duration: SOOus Output Voltage:0~45V (at 500 ohm load) Output Intensity Adjustable: 1 -25 (25 levels) Treatment Time: around SOminutes Operating Conditions: 5 C to 40 C; 30%RH to 75%RH Storage Conditions: -10 C to 55 C; 10%RH to 90%RH Size: 85mmx72mmx31mm Weight: 50g (without batteries) Troubleshooting Problem The unit cannot turn on Device is ON, but cannot feel the electrical stimulation Output stimulation is weak Stimulation is uncomfortable Output current stops during therapy Check points Are the batteries exhausted? Are the batteries installed correctly? Is the snap cables properly connected with glove and pad? Your hand may be dry. Are the snap cables dirty? Is the intensity too weak? Is the intensity too high? Are you operating the device according to the manual? Damaged or worn the cable, glove or pad. Replace new snap cable, glove or pad Are the cables disconnected with the glove and pad? Have the batteries been exhausted? Possible solution Replace the batteries. Insert the batteries observing polarity. Firmly connect the cable with the glove and pad. Moisturize your hand with conductive jelly which from your local pharmacy, and then try the procedure again. Clean the snap cables with a damp, lint free cloth. Use a higher intensity level. Choose a lower intensity or different program. Please operate the device according to the manual Turn off the power and connect the cables with the glove and pad. Please replace them with new batteries. 18 19
Page 1 and 2: Electronic Hand Stimulator And Mass
Page 3 and 4: Introduction Thank you for purchasi
Page 5 and 6: Safety information Stimulation shou
Page 7 and 8: Instructions for use How to connect
Page 9: Instructions for use Turn the devic
Page 13 and 14: Normalized symbols Used, fully disc
Page 15: Manufactured for: ProMed Specialtie

Electronic Hand Stimulator And Massager

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?