Buggy 150/250 Lubrication Guide
Engine Oil Service Procedures, Instructions and specifications GY6150 CN250
Engine Oil Service Procedures, Instructions and specifications GY6150 CN250
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
GOKARTSUSA.COM<br />
(800) 603-1437<br />
section of the CVT Gear Box. On the CVT Gear Box, you will also see a bolt<br />
about halfway up the final drive section. This is the Fill / Inspection hole for the<br />
gear oil. Place measuring cup under the drain screw. Use a 10mm wrench to<br />
remove the Drain Screw and the Fill Screw and let the oil completely drain into<br />
the measuring cup. Removing the Fill Screw at this time will allow the oil to drain<br />
faster. Using a measuring cup allows you to see if you have lost some oil. Once<br />
the oil is fully drained, replace the Drain Screw and wipe the oil off of the<br />
bottom of the gear box.<br />
Fill CVT Gear Box with Oil<br />
Fill the Oil Gun with about 3.7 ounces of Gear Oil. This amount may vary depending upon<br />
your engine. Insert the tube of the Oil Gun in the filler hole and squirt the oil gently into the<br />
box. Do not squirt so fast that the oil does not have time to flow into the box. Fill the Gear<br />
Box until oil begins to flow from the fill hole. You cannot over fill the Gear Box. Pull the oil<br />
gun tube out and allow the excess oil to flow out. Replace the Fill Screw and wipe off the<br />
excess oil from the Gear Box and check for leaks. Take a short ride and check for leaks<br />
again.<br />
Pistol Grip Oil Can: Using a Pistol Grip Oil Can will make the job much easier<br />
GokartsUSA is a Nationwide Supplier of Powersports Products<br />
7
Change language